Additional commands menu

Commands menu

• Create a loop A loop is a connector that returns the user to the same block.

• Create a block below

A command for quickly creating a new block (default type: Start) connected to the current block by a connector. You can create any number of blocks.

• Recalculate statistics

The "Recalculate statistics" command helps to see the number of users in blocks (states) at the moment the button is pressed.

To update this statistics, press the "Recalculate statistics" command again in any block within the funnel builder.

• Create a mailing

The "Create a mailing" command can be used both to create mailings from a block and to move clients from one state (funnel block) to another.

After selecting the mailing type (to messengers or email), the mailing form will open. When creating a mailing this way, the message text, attachments, and other settings are automatically taken from the block where the "Create a mailing" command was triggered:

1. To access the settings, click the "Messenger broadcast" button.

1. The "Message" tab in the mailing settings

Example: Send users to another block

Step-by-step instructions on how to bulk move clients (users) to another funnel block, using messenger users as an example.

Step 1. Copy the source block ID

Identify and copy the ID of the block FROM which you want to retrieve clients (for example, the "Main Block"):

1. Open the block editor

2. Look at the top information bar of the block

3. Click directly on the block number to copy its ID

Step 2. Start creating a mailing in the block TO which you want to move clients.

Open the block editor of the block where clients should be moved. In the top bar of the editor:

• Click the three dots (Additional commands menu) (1)

• Select "Create a mailing" (2)

• Choose "Messenger broadcast" (3)

Step 3. Create the mailing: configure the Recipients section

In the mailing creation form, navigate to the Recipients section and apply a filter to select clients from your source block:

1. Locate the filter settings for recipients

2. Set up a condition to filter by block ID

3. Enter the block number you copied in Step 1 as the filter value

Select the block. Before sending, recalculate the number of mailing recipients.

The mailing content will be automatically populated from the target block — the same block where users will be redirected after receiving this mailing. Step 4. Send the mailing. After successfully sending the mailing, you can click Recalculate statistics in the block.